Make the Probe

Fig. 1

The easiest way to make the probe is to insert a cable
(preferably a silicone cable) in a nipple that fits your boiler. The casting can be hard silicone rubber or reinforced epoxy that can withstand over 100 degrees. See Figures 2 and 4.

Another way is to fit a teflon tube into a bush with a brass shaft. See Figures 1, 2 and 3. The fitting must be tough. (The teflon expands in heat and moisture which makes it dense)

Probar.gif

Fig. 2

 
 
 
DSCN2608.gif

Fig. 3

Fig. 4

IMG_1630.gif
IMG_1631.gif

Tips & Ideas

Sometimes it can be difficult to fit the probe because of too few boiler bushes in the boiler. One way is through the water gauge upper nipple. See Figures 1 and 2.

Another way is to enter a blanking plug. See Figures 3 and 4.

fig 1

fig 2

fig 3

Exposeit Sweden

Änglundavägen 3

643 24 Flen

+ 46 707480778

© 2018 by C Axelsson. Exposeit.

  • Facebook Social Icon
  • Twitter Social Icon
  • Google+ Social Icon
  • YouTube Social  Icon
  • Pinterest Social Icon
  • Instagram Social Icon
This site was designed with the
.com
website builder. Create your website today.
Start Now